Table of Contents
Advertisement
7
The following example explains how to activate
TCP/IP protocol to connect the printer in the net-
work. You can select Netware or EtherTalk in a
similar manner.
>TCP/IP
On
If TCP/IP is currently Off is displayed, select On
using the
or
>TCP/IP
? On
8
Press the
key. Each time the
pressed, the item changes as shown below.
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
9
Display the item to be set and press the ENTER key.
For DHCP, a question mark (?) appears. For IP Ad-
dress, Subnet Mask, and Gateway, the cursor (
blinks.
10
For DHCP , select On or Off using the
For IP Address, Subnet Mask, and Gateway ad-
dresses, press the
(000 to 255) where the cursor is blinking. You can
use the
and
key to move the cursor right and
left.
To obtain these addresses, consult your network
administrator.
11
Press the ENTER key.
12
Press the MENU key. The message display returns to
Ready.
>
key. Press the ENTER key again.
>TCP/IP
On
or
key is
or
or
key to change the number
>
)
key.
Chapter 1 Using the Operator Panel
1-45
Advertisement
Table of Contents
