Table of Contents
Advertisement
Resetting Remaining Toner Counter
If the toner container was replaced when Replace toner
Clean Printer was not displayed, reset the toner counter
as follows so that an accurate toner gauge measurement is
indicated on the status page. Note that if this operation is
performed when the toner container is not replaced, the ton-
er gauge measurement will not be indicated correctly.
Installation Guide
Also see the
when replacing the toner container.
1
Press the MENU key.
2
Press the
or
Counters > appears.
Life Counters >
3
Press the
key.
4
Press the
or
Installed appears
>New Toner
Installed
5
Press the ENTER key. A question mark (?) appears.
>New Toner
Installed ?
6
Press the ENTER key. The toner counter is reset.
7
Press the MENU key. The message display returns to
Ready.
Selecting Message Language
You can select the language of the messages on the message
display by following the procedure given below.
1
Press the MENU key.
2
Press the
or
pears.
Others
3
Press the
key.
supplied with the toner kit
key repeatedly until Life
key repeatedly until >New Toner
key repeatedly until Others > ap-
>
Chapter 1 Using the Operator Panel
4
Press the
or
Language appears. The default message language is
English.
>MSG Language
English
5
To change the language, press the ENTER key. A
blinking question mark (?) appears.
>MSG Language
? English
6
Press the
key. The display cycles through the
available selections in the following order (the
cycles in the reverse order):
English
Francais
Deutsch
Italiano
Nederlands
Espanol
Portugues
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Setting Automatic Form Feed Timeout
When the printer receives no data for a certain time, it times
out and releases the current interface: it prints whatever
data it has in its buffer and feeds out the page. You can ad-
just the time-out time as follows:
1
Press the MENU key.
2
Press the
or
pears.
Others
3
Press the
key.
4
Press the
or
Time Out appears. The default setting is 0 seconds.
>Form Feed
Time Out 000sec.
key repeatedly until >MSG
key repeatedly until Others > ap-
>
key repeatedly until >Form Feed
key
1-53
Advertisement
Table of Contents
