Table of Contents
Advertisement
Printed Results
Faint or blurred printing
Grey background
Dirt on the top edge or back of the paper
Characters out of position
Corrective Action
Check the EcoPrint setting.
When this setting is On, switch it to Off on the operator panel.
Check the operator panel.
If the Toner low message is displayed and the ATTENTION
•
indicator is flashing, install a new toner kit. See
on page 1-33
.
Make sure the paper type setting is correct. See
•
page 2-6
.
Clean the charger wire.
Open the printer top and front covers. Remove the process unit and
clean the charger wire by moving the charger cleaner (green-colored)
to the right and left two or three times. See
Check the operator panel.
If the Toner low message is displayed and the ATTENTION
indicator is flashing, install a new toner kit. See
Replacement on page 3-1
.
Check the process unit installation.
Open the printer top and front covers. Check that the process unit is
correctly installed.
Check the transfer roller (black-
colored).
Open the printer top and front
covers. Remove the process unit
and check the transfer roller.
If the transfer roller is dirty with
toner, try printing several pages.
Check the registration roller
(metal).
Open the printer top and front covers. Remove the process unit and
check the registration roller.
If the registration roller is dirt with toner, wipe it away with the
wiper cloth supplied with the toner kit.
Check the file or program.
Check whether the problem is being caused by a PRESCRIBE
command error. If the problem occurs only with a specific file or
program, the most likely cause is an error in a parameter to a
command or command syntax.
Chapter 4 Troubleshooting
Setting EcoPrint
Paper Type on
Cleaning on page 3-3
Toner Container
.
4-3
Advertisement
Table of Contents
