Local Simulation Debugging With A Local Foreign Model - Intel IXP2400 User Manual

IXP2400/IXP2800 Network Processors
Developer Workbench
The Workbench supports debugging in four different configurations:
Mode
Local Simulation
Local Simulation
Local Simulation
Hardware
2.13.1

Local Simulation Debugging with a Local Foreign Model

The IXP2400 and IXP2800 Transactors support connecting multiple foreign model DLLs. The
Workbench allows you to specify an unlimited list of DLL file paths for foreign model DLLs. For
each DLL, you can specify an unlimited number of instantiations.
To specify the dynamic-link libraries that contain your foreign models:
1. On the Simulation menu,
click Options.
The Simulation Options
dialog box appears.
2. Click the Foreign Model
tab.
3. Click the
insert the path to your DLL.
4. Type in the complete path,
or
Click the
browse for the file.
When the path is set up, you
must specify at least one
instance.
5. Double-click the blank cell
under Instance Name.
106
Foreign
Model IXP2400 and IXP2800
None Default. No special setup necessary.
Local See Section 2.13.1
Remote See Section 2.13.1
None N/A
button to
button to
Comments
The Workbench and the simulator
(Transactor) both run on the Windows
platform.
The Workbench, the Transactor and
the foreign model Dynamic-Link
Libraries all run on the same Windows
platform.
The Workbench and the Transactor
both run on the same Windows
platform and communicate over the
network with a foreign model running
on a remote system.
The Workbench runs on a Windows
host and communicates over a network
or a serial port with a subsystem
containing an actual network
processor.
Development Tools User's Manual