IXP2400/IXP2800 Network Processors
Developer Workbench
2.13.1.3
Portmapper
Portmapper is automatically installed as part of the IXA SDK installation process. To ensure that
Portmapper is installed and running:
1. On the Window's task bar, click Start, point to Settings, and then click Control Panel.
2. Double-click Administrative Tools, and then double-click Services.
3. Look for the IXP2000 Portmapper. It should indicate that it has been "Started".
4. If it is not running, select IXP2000 Portmapper, right-click and then click Start.
Note: The executable is installed as C:\IXA_Portmapper\portmapper.exe.
2.13.2
Starting and Stopping the Debugger
Starting:
To enter debug mode:
On the Debug menu, click Start Debugging, or
Press F12, or
Click the
Once the debugger begins, you can interact with it through the command line window and by using
the Debug menu and toolbar selections that become activated. (See
Stopping:
To exit debug mode:
•
On the Debug menu, click Stop Debugging, or
Press CTRL+F12, or
Click the
Project debug settings such as breakpoints are automatically saved in a debug options file (.dwo)
when you save a project.
2.13.3
Changing Simulation Options
2.13.3.1
Marking Instructions
You can select how instructions are marked in a thread window when a thread execution is stopped,
such as at a breakpoint (see
To modify the instruction marker:
1. On the Simulation menu, click Options.
2. Click the Markers tab.
Note: For more information on thread windows, see
108
button.
button.
Figure
32).
Table 9
Section
2.13.8.
Development Tools User's Manual
and
Table
11.)