D Quick Tuning Step; D Selecting "Khz" Step - Icom IC-7800 Instruction Manual

3
BASIC OPERATIONS

D Quick tuning step

Select mode
Quick tuning indicator

D Selecting "kHz" step

D
⁄ tuning step function
1
4
1
⁄ tuning step OFF
4
Main dial [TS] [TS]
Quick tuning indicator
1
⁄ tuning step ON
4
3-6
The operating frequency can be changed in kHz steps
(0.1, 1, 5, 9, 10, 12.5, 20 or 25 kHz selectable) for
quick tuning.
q Push [TS] to turn the quick tuning function ON.
• "Z" appears when the quick tuning function ON.
w Rotate the main dial to change the frequency in pro-
grammed kHz steps.
e Push [TS] again to turn OFF the indicator.
r Rotate the main dial for normal tuning if desired.
q Push [TS] to turn the quick tuning function ON and
OFF.
• "Z" appears when the quick tuning function ON.
w Push [TS] for 1 sec. to enter tuning step setting dis-
play.
• Selected tuning steps for all modes appear.
e Select the desired operating mode.
r Rotate the main dial to select the desired tuning step.
t Repeat steps e and r to select quick tuning steps
for other modes, if desired.
y Push [EXIT/SET] to exit the setting display.
NOTE: When entering into quick tuning step set
mode, the quick tuning function must be activated,
and the set mode can be accessed from either
band's quick tuning switch, [TS]. Therefore, use the
same band's [TS] for quick tuning function selection
and the set mode entering.
When operating in SSB data, CW, RTTY or PSK, the
1
⁄ tuning function is available. Dial rotation is reduced
4
1 1
to ⁄ of normal when the
4
➥ Push [1/4] to toggle the
OFF.
• " " appears when the
1
⁄
4
⁄ tuning function is in use.
4
1
⁄ tuning function ON and
4
1 ⁄ tuning function ON
4