Tone Scan - Icom IC-7800 Instruction Manual

9
SCANS

■ Tone scan

[TONE] [F-4•DEF]
[F-1•Y] [F-2•Z]
[F-6•T-SCAN]
[EXIT/SET]
The transceiver can detect the subaudible tone fre-
quency in a received signal. By monitoring a signal that
is being transmitted on a repeater input frequency, you
can determine the tone frequency required to access
the repeater.
q Set the desired frequency or memory channel to be
checked for a tone frequency.
w Push [AM/FM] several times to select FM mode.
e Push [TONE] for 1 sec. to enter tone frequency
screen.
r Push [F-1•Y] or [F-2•Z] to check the repeater tone
frequency or tone squelch frequency, respectively.
t Push [F-6•T-SCAN] to start the tone scan.
• "SCAN" blinks while scanning.
y When the tone frequency is detected, the tone scan
pauses.
• The tone frequency is set temporarily on a memory
channel. Program into the memory channel to store the
tone frequency permanently.
• The decoded tone frequency is used for the repeater
tone frequency or tone squelch frequency.
u To stop the scan, push [F-6•T-SCAN].
• Push [F-4•DEF] for 1 sec. to select the default frequency.
i Push [EXIT/SET] to exit tone frequency screen.
9-8