Advertisement
Function Buttons
—'a
Stitch Re-start is used to start sewing
your selected stitch at the beginning of
the stitch, without having to re-set any
special settings you have made.
STOP is used to conclude a stitch. Your
Desier II fastens the thread and stops
automatically when a stitch sequence has
been completed. ST( )P is cancelled when
you touch the button again or by selecting
a new stitch. When STOP is active, the
button lights up.
FiX is automatically activated when a stitch
FIX
is selected or when the Selective Thread
Cutter has been used. FIX is used to tie
off stitches. The button lights up while
the FIX function is active. By touching the
lighted button the function can he turned
off. When beginning to sew, Designer 11
sews a few tie off stitches and goes on
with the selected stitch. Touch FIX while
sewing and Designer 11 sews a few tie off
stitches and stops automatically.
Reverse is pressed to sew in reverse. The
button lights up. When the button is re
leased. the light goes out and Designer II
sews forwards. The longest reverse stitch
length is 3 mm.
For permanent reverse, touch the button
twice in quick succession before starting
to sew. The button will he lit up and the
Designer II sews in reverse until you
touch the button again.
Needle stop up/down is used to move
the needle down or up and/or to set the
needle stop position up or down.
+
Touch
+
SPEED or
-
SPEED to increase or
SPEED
decrease the sewing speed. If touched
when not sewing, a Pop-up menu on the
—
Touch Screen indicates the speed setting.
SPEED
Touch OK or start sewing and the Pop-up
goes out. You can change the speed selling
while sewing hut no Pop-up will appear.
All stitches in I)esigner 11 have a preset.
recommended sewing speed. When you
select a stitch I)esigner 11 automatically
sets the correct sewing speed.
START/STOP is touched when
OU
want
to run and stop the machine without
using the foot control. Touch START/
STOP to begin and touch it again to stop
sewing.
Thread
Cutter
is touched to cut the top
and bobbin threads. If touched when the
machine is not sewing. the threads are cut
in the beginning of the following stitch. If
the button is touched while sewing.
the"STOP" button starts flashing and the
threads are cut at the end of the current
stitch. When the threads are cut, the
presser foot and the needle are raised to
the up position and the FIX function is
activated.
Sensor Foot Lift and Extra Lift is used
when you want the presser foot and the
needle to be lifted to up position. Touch
the button once more and the presser
foot will raise to extra lift, to make it easy
to get thick fabric
under
the presser foot.
See page 13.
Sensor Foot Pivot is used to simplify
placing the fabric. louch this button and
the presser foot will be lowered to pivot
position See page 13.
Sensor Foot Down is touched when you
want the presser foot to be completely
lowered. I)esigner 11 is firmly holding
your work, ready to sew. See page 13.
Learn yOur [)esi,c.ner II
4
4
4
START
STOP
g
Advertisement
