E Mail - Dedicated Micros DV-IP Installation And Operation Manual

E Mail

The unit can automatically transmit an e-mail to an SMTP Server under numerous conditions i.e. on
start up, on receipt of an alarm, camera failure etc. This allows the unit to be installed in unmanned
applications where a Remote Video Response Centre �or Manager etc.�� would be notified by e-mail
if any of these conditions occur.
Connection Profile
Mail Server Address
��ecipient Email
Display Name (��ecipient)
��eply to Email
Display Name (��eply To)
Sender Email
Display Name (Sender)
Send on Startup
Dedicated Micros ©2008
It is possible for the e-mail to be transmitted via the Ethernet
network or dial up connection (PPP 'Point to Point Protocol').
This setting presumes that a modem has been connected or
configured and the unit is connected to a ��N or ��N and
allocated a valid IP address.
This is the IP address or URL of the SMTP Server that the e-mail
will be sent to. The SMTP server will then forward this to the
intended recipient.
This is the e-mail address of the intended recipient.
This is the addressee name that will be shown in the email name
field.
This field must be configured if the recipient is to reply to an e-
mail. The unit does not accept incoming e-mails therefore ensure
this is a valid e-mail address.
This is the 'reply to' name that will be shown in the email name
field.
These optional fields indicate the source of the e-mail notification.
If the fields are left blank the unit will use the system name to
create a sender name.
This is the sender name that will be shown in the email name
field.
Select to send email notification on startup.