Dedicated Micros DV-IP Installation And Operation Manual page 114

PTZ Program Option
The Program page allows preset settings for PTZ cameras to be established and an 'Origin' base
position established for a camera.
Note: This page will not be available for all cameras.
��ed
Note: When entering a new preset, any previous preset assigned to that number (for the same
camera) will be overwritten.
Green
��ellow
�lue
Note: This option is only available for Oracle dome cameras.
Purple
11
Store Use to save the current camera view as a Preset
for that camera. Press this button then a preset
position (using the numeric keys on the I��
��emote Control or optional �eyboard if viewing
via a local monitor).
To re-send the camera to this position, select
the camera, then press Ne�t -> Preset -> (preset
number).
Dome Menu Select to display menu pages displaying
information relevant to the connected camera.
Select Dome Menu �Green� again to cycle
through available menus.
Select This option will send the camera to
the stored 'Preset1' position.
Set Origin The Origin option allows a base position to
be established for the Oracle dome camera.
The camera will register this position as zero
degrees. �ny command that sends the camera
to a coordinate will use this origin as its starting
point. Refer to 'Console Settings:-Map Config
:-Hotspot Origin' for more information).
�ack ��eturn to the previous page of the �iewer menu.
Dedicated Micros ©2008