Figure 37 Partitions Setup Screen; Table 14 Partitions Setup; Quantum Scalar 50 User's Guide - Quantum Scalar 50 User Manual

Figure 37 Partitions Setup
Screen

Table 14 Partitions Setup

Quantum Scalar 50 User's Guide

1 From the screen, use the up and down arrows to highlight
Setup
and press
Partitions
The
Partitions Setup
The
Partitions Setup
table 14):
Partitions Setup Description
Barcode swap Select the barcode swap to change the barcode
swap option (enable/disable). When enabled, the
media type prefix is swapped from the back of
barcode to the beginning.
Emulation
Select the emulation option to change the library
emulation mode. Emulation options are: Scalar 50,
PX500, or P2000.
Auto clean
Select the auto clean option to change the library
autoclean mode (enable/disable). When enabled,
the library will automatically load a cleaning
cartridge when a tape drive requests a cleaning.
Configure Slots The configured slots option allows you to
designate the number of slots available and
reported to the host. Use the up and down arrows
to highlight
the number of configured slots and press
The library will reconfigure with the new slot
count.
Chapter 2 Basic Library Operations
.
Enter
screen displays (see figure
screen displays the following options (see
Configure Slots
OCP Components
37):
and press . Enter
Enter
.
Enter
53