Figure 120 Date And Time Screen; Table 53 Setting Up The Cabinet - Quantum Scalar 50 User Manual

Table 53 Setting Up the
Cabinet
Figure 120 Date and Time
Screen
Quantum Scalar 50 User's Guide
Cabinet Options
Host bus
Stack role
Left load port
Right load port
Drive FUP from tape
Setting the Date and Time
To set the date and time:
1 From the Setup screen, use the up and down arrows to highlight
Date and Time and press Enter.
The Date and Time screen displays (see
The Date and Time screen displays the following information about
the library:
Appendix C Installing the Scalar 50 Library
Description
Sets the SCSI ID for both the library
and tape drives.
Assigns the library stack role as
Master, Slave, or Stand alone. There
can be only one Master library in a
multiple stack. Once configured as a
slave, all library OCP functions can be
controlled via the Master library OCP.
Enables or disables the left load port
Enables or disables the right load port
Allows you to perform a tape drive
firmware update from a firmware
update tape cartridge.
figure 120):
Installing the Library
3
211