Post Cbwinstructions; Vm Installation; Figure 4-4. Activescale Sm Welcome Screen - Quantum ActiveScale P100E3 Installation Manual

Hide thumbs Also See for ActiveScale P100E3:

Table of Contents

ActiveScale™ P100E3 Installation Guide

Upon first login, the ActiveScale SM Welcome screen appears.

4.12 Post CBWInstructions

Remove the factory installation SSH keys by running following bash commands:

Note: This should be run on all three nodes again.

sudo su - marvin

grep -v 'factory-install-key$' /home/marvin/.ssh/authorized_keys > /home/marvin/.ssh/authorized_keys_new

mv /home/marvin/.ssh/authorized_keys_new /home/marvin/.ssh/authorized_keys

To configure SNMP follow the ActiveScale_OS_Administrator_Guide instructions section 8.20 Configure

SNMP traps or polling

To configure syslog streaming follow the ActiveScale_OS_Administrator_Guide instructions section 8.31

Enable or disable syslog streaming

When you have reached this phase, you have an operational P100E3 setup.You can log in the ActiveScale

Management GUI for administrating the system. The system can be used for S3 operations.

P100E3 Converged Node Architecture Installation using an USB flash drive with ActiveScale ISO

These instructions apply to the P100E3 Converged Node Architecture setup. This is an entry level

ActiveScale system consisting out of 3 nodes. We will bootstrap the install of all three nodes using an USB

Flash Drive.

Table of Contents