Quantum Scalar 50 Quick Start Manual

Quick Start Guide

Introduction

The Scalar 50 tape library is an automated storage and retrieval device
consisting of up to two full height tape drives or four half height tape drives
and up to 32 SDLT cartridges or 38 LTO tape cartridges (see
This instruction uses the following conventions:
Note: Notes emphasize important information related to the main
topic.
Cautions indicate potential hazards to equipment and are
Caution:
included to prevent damage to equipment.
Warning: Warnings indicate potential hazards to personal safety and
are included to prevent injury.
This document explains how to unpack the Scalar 50 tape library and install
it in a standard 19 in. rack. Once the library is unpacked and installed, set
up the library using the instructions in the Scalar 50 User's Guide PN 81-
81768. This installation procedure will take approximately 4 hours to
complete.
It is recommended to review the entire document prior to
Note:
beginning the installation.
Scalar 50
figure 1).
Scalar 50 Tape Library
Contents
Introduction..............................................1
Choosing a Location.................................2
Rack Space Requirements .....................2
Environmental Conditions ....................2
Preparing for the Installation..................3
Providing Necessary Tools ....................3
Taking ESD Precautions .........................3
Unpacking the Scalar 50 Tape Library .....4
Installing the Library................................6
Locating the Mounting Position...........6
Installing the Library.............................7
Initial Configuration............................23
Setup Wizard ..........................................31
Multiple Library Stacks ..........................36
Testing the Library Configuration .........39
Enabling Capacity on Demand ..............42
0