Figure 118 Setup Screen; Figure 119 Library Options Screen - Quantum Scalar 50 User Manual

Figure 118 Setup Screen

Figure 119 Library Options
Screen
Quantum Scalar 50 User's Guide
12 From the Setup screen, use the up and down arrows to highlight
Cabinet and press Enter.
The Cabinet screen displays (see
13 The screen allows you to configure the library as a
Stack role
"Master" or "Slave" in a multiple library stack. The library is
configured "Stand alone" by default. If this is a multiple library stack,
use the up and down arrows to highlight
displays the following information about the library:
Note: All Scalar 50 libraries must have
configuration as a stack is possible. PX502 libraries in a
stack are considered fully licensed. Configure each unit
that will be stacked as a stand alone unit and enable
capacity through the remote management pages (see
Library
the stack role(s) accordingly to create the multiple library
stack.
Appendix C Installing the Scalar 50 Library
Enter
figure
on page 125). After full capacity is enabled, change
Installing the Library
119):
and press
Stack role
capacity before
FULL
Enter
Full
210