Figure 10 Inserting A Barcode Label (Sdlt) - Quantum Scalar 50 User Manual

Figure 10 Inserting a Barcode
Label (SDLT)
Quantum Scalar 50 User's Guide
You cannot choose the sequence of labels inside the bar code
Note:
label packs. No two packs are ever the same to avoid issues
with duplicate bar code IDs.
Place the label in the slide-in slot on the front of the cartridge (see
figure 10).
Slide-in slot
Only use barcode labels that have been designed for
Note:
cartridges. Do not adhere labels to a cartridge anywhere
except the slide-in slot.
Setting the Write-Protect Switch
Each tape cartridge has a write-protect switch similar to that shown in
figure 11. This switch determines whether new data can be written to the
cartridge (write-enabled) or whether data on the cartridge is protected
from being erased or overwritten (write-protected). Set the write-protect
switch to enabled when inserting new cartridges into the library. Set the
write-protect switch to protected archiving tape cartridges.
Chapter 2 Basic Library Operations
Installing Tape Cartridges
2
25