Loading Tape Cartridges; Initial Configuration; Figure 9 Connecting The Library To The Local Area Network - Quantum Scalar 50 User Manual

Figure 9 Connecting the
Library to the Local Area
Network

Loading Tape Cartridges

Initial Configuration

Quantum Scalar 50 User's Guide
1 The Scalar 50 tape drives and system controller board are accessed
from the back of the library (refer to
Workstations
2 Connect Ethernet port located on the back of the library on the
system controller board to the local area network (see
Ethernet port Internal communication
with TC2201 CPCI card
Before operating the library, load the appropriate tape cartridges (LTO or
1
SDLT) into the library starting with the left-hand magazine (see
and figure 3 for slot locations).
The Quantum Scalar 50 must be initially configured with an IP address
1
before the remote management software is available. Refer to
OCP on page 37 for information on configuring your Scalar 50 network
information and preparing for operation.
on page 31).
Chapter 1 Library Description
Getting Started
Connecting to Host
figure
System controller board
9).
figure 2
Using the
20