Figure 24 Inserting A Barcode Label (Sdlt) - Quantum px720 User Manual

Figure 24 Inserting a Barcode
Label (SDLT)
Quantum PX720 User's Guide
Place the label in the slide-in slot on the front of the cartridge (see
figure 24).
Slide-in slot
Only use barcode labels that have been designed for
Note:
cartridges. Do not adhere labels to a cartridge anywhere
except the slide-in slot.
Setting the Write-Protect Switch
Each tape cartridge has a write-protect switch similar to that shown in
figure 25. This switch determines whether new data can be written to the
cartridge (write-enabled) or whether data on the cartridge is protected
from being erased or overwritten (write-protected). Set the write-protect
switch to enabled when inserting new cartridges into the library. Set the
write-protect switch to protected archiving tape cartridges.
Proper Insertion Orientation
Refer to figure 25 for proper label placement, write protection settings
and insertion orientation.
Chapter 2 Basic Library Operations
Inserting Tape Cartridges
2
2
43