Using The Xlr Adaptor Of The Rcu; Rcu Usage Possibilities - Barco CLM HD8 R9050130 User Manual

3. Physical installation
Image 3-6
Mounting the XLR adapter
2. Fasten the two screws (S) of the XLR adaptor. Turn each screw repeatedly one or two turns until both screws are tight.
3.1.4

Using the XLR adaptor of the RCU

How to use the XLR adaptor of the remote control unit ?
1. Connect a cable with XLR plug into the XLR adaptor.
2. Connect the other end of the cable with your CLM HD8.
3. Push the XLR adaptor completely against the rugged case of the remote control unit, as illustrated in the left image below, for
wired communication. Pull out the XLR adaptor (about 8 mm) to switch over to wireless communication.
Image 3-7
3.1.5

RCU usage possibilities

Summarized possibilities
Ref. Possibility description
a.
RCU not wired
b. RCU wired (mini-jack)
c.
RCU with rugged case not wired
d. RCU with rugged case wired (mini-jack)
e.
RCU with rugged case and XLR adaptor
pulled out "REMOTE" and not wired
f. RCU with rugged case and XLR adaptor
pulled out "REMOTE" and wired
g.
RCU with rugged case and XLR adaptor
pushed in "WIRED" and wired
22
C
Comment
Backlight illuminates continuously when wire is connected. Infra red
disabled.
Backlight illuminates continuously when wire is connected. Infra red
disabled.
The XLR adaptor must be in the pulled out position "REMOTE",
otherwise the RCU will not function.
The RCU will send the commands via infra red to the projector.
The RCU will send the commands via the cable connected with the XLR
adaptor to the projector. Backlight illuminates continuously when wire
is connected. Infra red disabled.
S
R59770057 CLM HD8 16/07/2007
S