Barco CLM HD8 R9050130 User Manual page 178

D. Troubleshooting
Error Description
code
2005 Lamp stop
failed
2100
LPS 1 error
2400 LPS 2 error
2700 LPS 3 error
3000 LPS 4 error
3899 Spi flash
invalid type
3898 Spi flash busy
3999 IR buffer full
4000 Incompatible
hardware
4199 FIB reset
failed
4198 FPGA PMP
init failed
6099 Board ID
unkown
version
6098 Board ID
invalid string
7999 DMD temp low
7998 DMD temp
high
7997 Ambient temp
low
7996 Ambient temp
high
7994 TEC temp
high
7992 LPS1 temp
high
7990 LPS2 temp
high
7988 LPS3 temp
high
174
Error Warn- Caused by
ing
-
Yes
-
Yes
-
Yes
-
Yes
-
Yes
Yes
Yes
Yes
Yes No Incompatible hardware used
-
Yes no communication with FIB
-
Yes
Yes
Yes
Yes Yes Low temperature on DMD
Yes Yes High temperature on DMD
Yes Yes Ambient temperature out of
specifications
Yes Yes Ambient temperature out of
specifications
Yes Yes
Yes Yes High temperature on LPS1
Yes Yes High temperature on LPS2
Yes Yes High temperature on LPS3
Action
Call qualified service engineer
Replace LPS
Replace LPS
Replace LPS
Replace LPS
Change to correct hardware
Call a qualified service engineer
turning on the lamp(s) will heat up
the DMD
check if air slots are free, clean air
filters.
If problem persists, call a qualified
service engineer.
take measurements to increase the
temperature
check ambient conditions
check if air slots are free, clean air
filter.
check if air slots are free, clean air
filters.
If problem persists, call a qualified
service engineer.
check if air slots are free, clean air
filters.
If problem persists, call a qualified
service engineer.
check if air slots are free, clean air
filters.
If problem persists, call a qualified
service engineer.
R59770057 CLM HD8 16/07/2007