Troubleshooting; Error Codes; D.1 Error Codes - Barco CLM HD8 R9050130 User Manual

D. TROUBLESHOOTING

D.1 Error codes

Overview
When the error code is preceded by a '-' sign, then the error means a real error for the projector.
When the error code is preceded by a '+' sign, then the error code means a warning. The projector does not fail yet, but take care
for the warning and try to resolve the problem. A warning state can turn into an error state.
Not all error codes can have two states. When the state is available, it is indicated by a Yes in the overview table. When the state
is not available, it is indicated by a No.
Error Description
code
1000 Wrong lamp
parameters
1399 I²C open error
1398 I²C read error
1397 I²C write error
1499 Video input
invalid
1498
1699 Formatter
busy
1698 Formatter
address
1697 Formatter init
failed
1696 Formatter ctrl
init failed
1695 Formatter
start failed
1694 Formatter
PWGGood
1999 MAX7301 not
initialized
2000 No lps
detected
2001 Mains voltage
too low
2002 Lamp start
failed
2003 Main voltage
too high
2004 Lamp goes out
R59770057 CLM HD8 16/07/2007
Error Warn- Caused by
ing
-
Yes Wrong lamp/ no communication
with lamp
Yes
Yes
Yes
-
Yes no communication with formatter
ctrl
-
Yes no communication with formatter
ctrl
-
Yes no communication with formatter
-
Yes formatter 'Power Good' signal not
OK
Yes
-
Yes no communication with lamp power
supply
-
Yes mains voltage too low
-
Yes Hot restrike
Lamp with many strikes
maximum run time exceeded
Lamp or LPS or SPG failed
-
Yes mains voltage too high
-
Yes
D. Troubleshooting
Action
Check lamp type
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Let cool down the lamp for at least
5 minutes. Retry a few times.
Replace the lamp with a new one
Replace LPS or SPG or cabling.
Call qualified service engineer
173