Rcu Xlr Adaptor Installation; Using The Xlr Adaptor Of The Rcu - Barco FLM HD18 User Manual

Image 3-5
3.1.3

RCU XLR adaptor installation

Install the rugged case before installing the XLR adaptor.
Necessary tools
5 mm flat screw driver.
How to install the XLR adaptor of the remote control unit ?
1. Push the XLR adaptor (C) upon the rugged case of the remote control unit as illustrated.
Note: Ensure that the positioning pin of the XLR adaptor fits into the receiver of the rugged case.
Image 3-6
2. Fasten the two screws (S) of the XLR adaptor. Turn each screw repeatedly one or two turns until both screws are tight.
3.1.4

Using the XLR adaptor of the RCU

How to use the XLR adaptor of the remote control unit ?
1. Connect a cable with XLR plug into the XLR adaptor.
2. Connect the other end of the cable with your FLM HD18.
3. Push the XLR adaptor completely against the rugged case of the remote control unit, as illustrated in the left image below, for
wired communication. Pull out the XLR adaptor (about 8 mm) to switch over to wireless communication.
R5976986 FLM HD18 01/09/2006
C
3. Physical installation
S
S
19