Table of Contents
Advertisement
Ind.
Key name
12
Lens shift
13
Picture controls
14
PHASE
15
FREEZ
16
TEXT
17
ENTER
18
Cursor keys
19
EXIT
20
WINDOW
21
PIP
22
RC Operating indication
Table 6-1
6.3
Operating the projector
Overview
•
Switching on
•
Errors, warnings and messages during start up
•
Switching to standby
•
Switching off
6.3.1
Switching on
How to switch on.
1. Press the power switch to switch on the projector.
Image 6-2
Power switch
-
When '0' is visible, the projector is switched off.
-
When '1' is visible, the projector is switched on.
The projector starts up in standby. The menus are accessible via the local LCD panel.
To display an image, the standby key must be pressed once.
R59770057 CLM HD8 16/07/2007
Description
Shift control of the lens, to shift the lens up/down or left/right
Use these buttons to obtain the desired picture level.
Used to remove the horizontal instability of the image (usually for RGB source). It
adjusts the phase of the pixel sampling clock relative to the incoming signal.
To freeze the actual projected image.
Toggle key to activate or deactivate on screen text boxes while adjusting a setting.
When adjusting one of the image controls, e.g.during a meeting, the normally displayed
bar scale can be deactivated by pressing 'TEXT' key first. To re-display the bar scale
on the screen, press 'TEXT' key again. When TEXT is 'off', no adjustment menu's
will be displayed on the screen when entering the adjustment mode. All menus and
adjustments remain active on the local LCD panel.
Key to confirm an adjustment or selection in the adjustment mode.
To make menu selections when in the adjustment mode
Key to go one menu stage higher than the actual position when in the adjustment mode.
Selection of the active window, also in PIP mode.
Direct access key for picture in picture selection.
Lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
6. Getting started
45
Advertisement
Table of Contents
