FIG. 27
NetLinx Studio - Repopulating the System Tree
Configuring a Wired Ethernet Connection
It is necessary to tell the panel to which Master it should be communicating. This "pointing to a Master" is
done via the System Settings page, where the IP Address, System Number and Username/Password
information assigned to the target Master is configured.
Until those parameters are configured, the Connection Status icon will remain red, indicating that it has no
connection to a Master.
Step 1: Configure the Panel's Wired IP Settings
This panel has only one method of communicating to a target Master over the Internet: Wired (direct Ethernet
connection, as wireless communication is not available on the NXD-430 or NXD-435). The connection
parameters may only be configured through the System Connection page.
This type of communication can be established either via either a Dynamic IP Address (DHCP) or via a pre-
reserved Static IP Address (typically provided by your System Administrator).
IP Settings section - Configuring a DHCP Address over Ethernet
1.
Press the System Settings button on the Protected Setup page to open the System Settings page (FIG. 28).
NXD-430/NXD-435 4.3" Wall/Flush Mount Touch Panels
Click to access the Display menu,
and select Refresh System Online Tree
Configuring Communication
29