Table of Contents
Advertisement
Installation
5.
Thread the incoming Ethernet and USB wiring from their terminal sources through the surface opening.
Leave enough slack in the wiring to accommodate any re-positioning of the panel.
6.
Insert all connectors into their corresponding locations along the left side of the un-powered touch panel.
The USB connectors can be from either a USB extension cable or a wireless USB RF transmitter.
7.
Test the incoming wiring by connecting the panel connections to their terminal locations. Verify that the
panel is receiving power and functioning properly before finalizing the installation.
Flat installation surface
FIG. 11
Wall Mount panel installation configuration for flat surfaces
Do not disconnect the connectors from the touch panel. The unit must be installed
with the necessary connectors before being inserted into the solid surface.
8.
Carefully slide the main unit into the cutout, making sure that the locking tabs lie flush against the back
box.
9.
Insert and secure three #4 Mounting Screws (not included) into the corresponding holes located along the
sides of the device, using a grounded Phillips-head screwdriver, until the unit is secure and flush against
the wall (FIG. 11).
10.
Reconnect the capacitive touch connector to the 10-pin plug on the faceplate.
11.
Place the faceplate back onto the device.
14
Locking Tabs
Ethernet and USB
Connectors
A - Faceplate
B - 10-pin capacitive
touch connector
NXD-430/NXD-435 4.3" Wall/Flush Mount Touch Panels
Advertisement
Table of Contents
