Table of Contents
Advertisement
Setup Pages and Descriptions
System Settings Page - IP Tab (Cont.)
Subnet Mask
Gateway
Host Name
Primary DNS
Secondary DNS
Domain
Ethernet Mode
MAC Address
Back:
System Settings - Master Tab
The Master tab of the System Settings page contains the necessary information for connecting to the network
Master.
FIG. 59
System Settings page - Master Tab
System Settings Page - Master Tab
Connection Status icon: Shows the current state of the panel's connection to the Master (green = online, red =
Type:
56
Sets a subnetwork address to the panel.
• Subnetwork mask is the technique used by the IP protocol to filter messages into a
particular network segment (Subnet).
Sets a gateway value to the panel.
• Gateway is a computer that either performs protocol conversion between different
types of networks/applications or acts as a go-between two or more networks that
use the same protocols.
Sets the host name of the panel.
Sets the address of the primary DNS server used for host name lookups.
• DNS (Domain Name System) is software that lets users locate computers on a local
network or the Internet (TCP/IP network) by host and domain. The DNS server
maintains a database of host names for its domain and their corresponding IP
Addresses.
Sets a secondary DNS value to the panel.
Sets the unique name on the Internet to the panel for DNS look-up.
• The panel belongs to the DNS domain.
Sets the speed of the Ethernet connection to the panel.
• Choices are: Auto, 10 Half Duplex, 10 Full Duplex, 100 Half Duplex, or
100 Full Duplex.
Displays a read-only field that is factory set by AMX for the built-in Ethernet interface.
Saves any changes and returns to the previously active touch panel page.
offline). See the Connection Status Icon section on page 46 for details.
Sets the NetLinx Master to communicate with the panel via either USB or Ethernet.
This is based on the cable connection from the rear.
Note: ICSNet is not a supported option on this panel.
• Ethernet is a CAT-5 cable (10/100Base T terminated in an RJ-45 connector) used
to network computers together and is used in most LAN (local area networks). This
description is also used to refer to both wired and wireless communication.
• USB option cannot be used on Modero panels that are not equipped with a USB
port.
NXD-430/NXD-435 4.3" Wall/Flush Mount Touch Panels
Advertisement
Table of Contents
