Table of Contents
Advertisement
Setup Pages and Descriptions
Protected Setup Page (Cont.)
Remove Pages:
Telnet:
Function Show:
Page Tracking:
Front Btn Access:
System Settings:
Calibrate:
G4 Web Control:
Passwords:
Panel Statistics:
Connection Utility:
Back:
Any use of the Reset Settings or Remove Pages buttons opens up the Confirmation Dialog window.
FIG. 56
Protected Setup page-System Settings confirmation dialog
54
Press this button to remove all current TPD4 touch panel pages currently on the
panel (including the pre-installed AMX Demo pages).
• Pressing this button launches a Confirmation dialog which asks to confirm your
selection.
• This dialog is configured with a delay timer that does not enable the YES button for
5 seconds. This delay provides an additional amount of time for the user to confirm
a decision.
Press this button to enable or disable the telnet server on the panel. This feature
focuses on direct telnet communication to the panel.
Press this button to enable the display of the channel port and channel code in the
top left corner of the button, the level port and level code in the bottom left corner, and
the address port and address code in the bottom right corner (see FIG. 57 on
page 55).
Press this button for the touch panel sends page data back to the NetLinx Master, or
vice versa depending on the touch panel settings.
Press this button to activate the grey Front Setup Access button (located below the
LCD) to access the firmware pages.
• Default condition is On.
• Press and hold the Front Setup Access button for 6 seconds to access the Setup
page.
• Press and hold the Front Setup Access button for 9 seconds to access the
Calibration page.
Press this button to configure communication settings between the NetLinx Master
and the panel.
Press this button to access the Calibrate Page (page 58).
Press this button to enable or disable remote display and control of the panel via a
Web-enabled PC.
Press this button to access the Passwords Page (page 60).
Press this button to access the Panel Statistics Page (page 60).
Press this button to access the Connection Utility Page (page 63).
Saves the changes and returns to the previously active touch panel page.
The Yes button is disabled for 5 seconds while a timer reads down between it and the No button,
and then becomes enabled.
Clicking either button will return you to the Protected Setup page.
NXD-430/NXD-435 4.3" Wall/Flush Mount Touch Panels
Advertisement
Table of Contents
