Configuring Multiple Wireless Moderos To Communicate To A Target Wap200G; Configuring A Wired Ethernet Connection; Step1: Configure The Panel's Wired Ip Settings; Ip Settings Section - Configuring A Dhcp Address Over Ethernet - AMX NXT-CV10 Operation/Reference Manual

Configuring Communication

Configuring multiple wireless Moderos to communicate to a target WAP200G

1.
For each communicating touch panel, complete all of the steps outlined within the previous Configuring
the Modero's wireless card for secured access to a WAP200G section on page 62.

2.
Navigate back to the Wireless/Wireless Settings page on each panel.
3.
Verify that all communicating Modero panels are using the same SSID, encryption level, Default Key #,
and an identical Current Key value.

4.
Repeat steps 1 - 3 on each panel. Using the same passphrase, generates the same key for all
communicating Modero panels.

Configuring a Wired Ethernet Connection

It is necessary to tell the panel which Master it should be communicating with. This "pointing to a
Master" is done via the System Settings page where you configure the IP Address, System Number and
Username/Password information assigned to the target Master. If you have previously established a wireless
connection to the Internet you must still navigate to the System Settings page and configure the
communication parameters for the target Master. Until those parameters are configured, your Connection
Status icon will remain red (indicating there is no current connection to a Master).


Step1: Configure the Panel's Wired IP Settings

There are only two available methods of communicating to a target Master over the Internet: Wireless (via an
internal card) or Wired (direct Ethernet connection). If you are not using an internal wireless card, you can
only configure the connection parameters through the System Settings page. This type of communication can
be established either via either a Dynamic IP Address (DHCP) or via a pre-reserved Static IP Address
(typically provided by your System Administrator).

IP Settings section - Configuring a DHCP Address over Ethernet

1.
Select Protected Setup > System Settings (located on the lower-left) to open the System Settings page.
2.
Locate the IP Settings section of this page.
Even though the Host, Gateway, Primary DNS, Secondary DNS, and Domain fields
appear on the two separate System Settings and Wireless Settings pages; the
information populating these fields is identical.
If the information within one of these fields is altered, the change is reflected on both
pages within the altered field.
Example: Domain is altered on Wireless Settings page, the value is then also
changed within the Domain field of the System Settings page.
3.
Toggle the DHCP/Static field (from the IP Settings section) until the choice cycles to DHCP.
DHCP will register the unique MAC Address (factory assigned) on the panel and
once the communication setup process is complete, reserve an IP Address, Subnet
Mask, and Gateway values from the DHCP Server.
4.
Press the optional Host Name field to open a Keyboard and enter the Host Name information.
5.
Press Done after you are finished assigning the alpha-numeric string of the host name.
6.
Do not alter any of the remaining greyed-out fields in the IP Settings section. Once the panel is rebooted,
these values are obtained by the unit and displayed in the DNS fields after power-up.
66
Those procedures walk you through assigning an SSID, selecting a WEP encryption level, and
obtaining a Current Key string value for a specific WEP Key on a target panel.
As an example, all panels should be set to Default Key #1 and be using aa:bb:cc..as the Current
Key string value. This same Key value and Current Key string should be used on the target WAP.
If you have previously configured an internal wireless card for communication to the Internet, you
do not need to configure the panel's IP Settings fields and can skip the following Step 1.
10" Modero Touch Panels