Table of Contents
Advertisement
Configuring Communication
FIG. 20
System Settings page - using a USB Connection type
6.
Toggle the Type field until the choice cycles to USB.
7.
Press the Back button to return to the Protected Setup page.
8.
Press the Reboot button both to save any changes and restart the panel.
Remember that the panel's connection type must be set to USB prior to rebooting the
panel and prior to inserting the USB connector.
No connection is established until the Virtual Master becomes active within NetLinx
Studio
9.
Only after the device displays the first panel page should you then insert the mini-USB connector into
the Program Port on the panel. It may take a minute for the panel to detect the new connection and send a
signal to the PC, as indicated by a green System Connection icon. If this is the first time for installing the
USB driver, a USB driver installation popup window appears on the PC.
10.
Click Yes when told that a digital signature was not found. This action accepts the installation of the new
AMX USB driver. The panel is now configured to communicate directly with the PC.
11.
Navigate back to the System Settings page.
24
Toggle to USB
All fields are then greyed-out and read-only, but still display any previous network information.
Refer to the System Settings Page section on page 55 for more information about the fields on this
page.
This window states that the panel has been detected by the PC as a USB-compliant device and the
PC is installing an appropriate USB driver to establish a proper communication to the panel.
This driver was installed on the PC during the installation of the latest NetLinx Studio and
TPDesign4 software application installations. These applications should be installed prior to
setting up a USB connection to the panel.
®
Windows
notes that the driver does not contain a Microsoft
This process completes the association between driver and device. Each time the same touch panel
is connected to the computer, the driver is automatically loaded (using a unique name - example
USB LAN LINK #1, #2). Each time a different touch panel is connected to the computer, the
previous procedures will need to be repeated.
Red
indicates no connection to the Virtual Master
Green
indicates communication with the Virtual Master
®
digital signature.
NXD-430/NXD-435 4.3" Wall/Flush Mount Touch Panels
Connection Status
Advertisement
Table of Contents
