Verifying Phone Startup; Updating Your Phone Firmware - Cisco SPA50X User Manual

Installing Your Phone

Verifying Phone Startup

Verifying Phone Startup

Updating Your Phone Firmware

Cisco Small Business SPA50X and SPA51X Series SPCP IP Phone User Guide
After receiving power and network connectivity, the phone executes a boot
sequence. During this sequence, phones with IP phone screens display the Cisco
logo, the message Initializing Network and all of the lights on the phone flash.
After your phone successfully connects to the network, it checks for and
downloads an updated configuration and firmware. When the boot process is
complete, the extension number appears on the IP phone screen (on models with
a IP phone screen) and the phone has a dial tone.
On models with IP phone screens, the phone displays the standard menu for the
phone. The date, name and number of the phone display on the top line of the IP
phone screen. At the bottom of the IP phone screen, softkeys are displayed over
their associated soft buttons.
On models with no IP phone screen, such as the
green and you hear a dial tone when the handset is picked up or when the speaker
button is pressed.
If the phone does not start, confirm your installation and connections. If these are
correct, try unplugging the phone and plugging it back in again. Cycling the phone
connection updates the configuration and the firmware. If you still do not see the
display, then contact your phone administrator or Internet Telephony Service
Provider (ITSP).
The phone firmware is updated automatically by the Cisco Smart Business
Communications System (SBCS), according to the administrative settings.
, the lines glow
Cisco SPA501G
2
22