Cisco SPA50X User Manual page 49

Using the Phone Web User Interface
Setting Voice System Parameters
Cisco Small Business SPA50X and SPA51X Series SPCP IP Phone User Guide
Parameter Description
Enable Web Choose yes to enable the phone web server that allows an
Admin Access administrator to modify the phone configuration by using
the phone web user interface. Choose no to make the
phone web user interface read-only.
Admin Passwd Alphanumeric string that allows administrator access to the
configuration profile.
User Password Alphanumeric string that allows user access to the
configuration profile.
Signaling Specifies the SPCP or SIP protocol.
Protocol
SPCP Auto- Choose yes to automatically detect the Simple Phone
detect Control Protocol (SPCP) or Session Initiation Protocol (SIP).
Choose no to disable automatic detection.
Phone-UI- Choose yes to allow phone users to change the phone
readonly parameters by using the phone interface. Choose no to
restrict ability of the phone users to modify the phone
parameters through the phone interface.
Phone-UI-user- Choose yes to restrict ability of the phone users to see the
mode phone interface. Choose no to restrict ability of the phone
users to see the phone interface.
PoE Power Choose Normal to signal the switch that the expected
Required power draw will be normal levels. Choose Maximum to
signal the switch that the expected power draw will be
normal levels.
Connection Type Choose DHCP to get the IP address from a DHCP server or
choose Static to set a static IP address.
Static IP If you selected a Static connection type, enter the static IP
address for the device.
Netmask If you selected a Static connection type, enter the
subnetwork mask.
Gateway If you selected a Static connection type, enter the gateway
IP address.
HostName Hostname of the phone.
5
48