Cisco SPA50X User Manual page 50

Using the Phone Web User Interface
Setting Voice System Parameters
Cisco Small Business SPA50X and SPA51X Series SPCP IP Phone User Guide
Parameter Description
Domain Network domain name.
Primary DNS Primary DNS server IP address.
Secondary DNS Secondary DNS server IP address.
DNS Server Method for selecting the DNS server. The options are
Order Manual (enter the IP address of the DNS server manually;
do not look at the DHCP-supplied DNS table), Manual/
DHCP, and DHCP/Manual.
DNS Query Mode Parallel or Sequential DNS query. A parallel DNS query
sends the same DNS lookup request to all of the DNS
servers at the same time. The first incoming reply is
accepted by the phone. A sequential query polls the DNS
servers in sequence. Defaults to parallel.
TFTP Server IP address or name of the primary TFTP server.
Alternate TFTP IP address or name of the secondary TFTP server.
Syslog Server Specify the syslog server name and port. This feature
specifies the server for logging device system information
and critical events. If both Debug Server and Syslog Server
are specified, Syslog messages are also logged to the
Debug Server.
Debug Server The debug server name and port. This feature specifies the
server for logging debug information. The level of detailed
output depends on the debug level parameter setting.
Debug Level Choose a debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means no
debug information is generated. Defaults to 0.
Layer 2 Logging Choose yes to enable Layer 2 Logging. Choose no to
disable it.
NTP Enable Choose yes to use Network Time Protocol (NTP) to set the
time on the device. Choose no to disable NTP.
Primary NTP IP address or name of the primary NTP server. The phones
Server use these servers to synchronize its time.
Secondary NTP IP address or name of the secondary NTP server. The
Server phones use these servers to synchronize its time.
5
49