Mounting The Utx878 Electronics Enclosure; Making The Electrical Connections; Preparing The Unit Before Making Electrical Connections - GE UTX878 Ultrasonic User Manual

March 2004
Mounting the UTX878
Electronics Enclosure
Making the Electrical
Connections
Preparing the Unit
Before Making Electrical
Connections
1-4
The standard Model UTX878 electronics package is housed in a
epoxy-coated aluminum weatherproof NEMA4X, IP67 enclosure
suitable for indoor or outdoor use. Figure 1-5 on page 1-11 shows the
outline and installation drawing. Refer to Chapter 7, Specifications,
for the mounting dimensions and the weight of this enclosure.
This section contains instructions for making all the necessary
electrical connections to the Model UTX878 flow transmitter. Refer
to Figure 1-7 on page 1-13 for a complete wiring diagram.
!ATTENTION EUROPEAN CUSTOMERS!
To meet CE Mark requirements, all cables
must be installed as described in
Appendix B, CE Mark Compliance.
Always disconnect the line power from the Model
UTX878 before removing the front cover.
Prepare the unit as described below before making any electrical
connections.
1. Disconnect any previously wired power line from the unit.
2. Remove the screws on the front cover.
3. Install any required cable clamps on the appropriate conduit holes
on the bottom of the enclosure.
Proceed to the next section to make the desired wiring connections.
!WARNING!
Installation