Introduction; Setting Up The Display - GE UTX878 Ultrasonic User Manual

Introduction

Setting Up the Display

Displaying Data
The Model UTX878 flow transmitter includes a Liquid Crystal
Display (LCD) that can display up to two variables simultaneously.
Users can change the number of variables, the displayed
measurements and units, and the contrast level of the LCD.
You can configure either of two channels for your particular
requirements. When you first power up the installed UTX878, the
display screen appears similar to Figure 3-1 below.
Ch 1
0.0
Meters/sec
Figure 3-1: A Typical Display Screen
To change the display screen, press either the [ ] or [ ] keys. The
screen will highlight one of the parameters, as shown in Figure 3-2
below.
Ch 1
0.0
Meters/sec
Figure 3-2: Display Screen with Highlighted Parameter
If you press the [ ] key, the UTX878 highlights the channel
parameter in the upper left; if you press the [ ] key, it highlights the
error code parameter in the lower right. Continue pressing the [ ] or
[ ] key to reach the desired parameter. When you have highlighted
that parameter, press [ENT].
IMPORTANT: On any menu, if you scroll to a different option, press
[ENT] twice to select that option (once to enter and
again to confirm the selection).
Velocity
E1
Velocity
E1
March 2004
3-1