What's Next - GE UTX878 Ultrasonic User Manual

March 2004
Wiring the RS232 Serial
Port (cont.)

What's Next?

1-10
3. Feed the flying leads end of the cable through the conduit hole and
wire the leads to the COMMUNICATION terminal block (TB4)
as shown in Figure 1-7 on page 1-13. Connect the other end of the
cable to the ANSI terminal or personal computer, and secure the
cable clamp.
4. Tie the shield drain wire to the UTX878 ground bus bar.
!ATTENTION EUROPEAN CUSTOMERS!
To meet CE Mark requirements, all cables
must be installed as described in
Appendix B, CE Mark Compliance.
After the wiring has been completed, replace the front cover on the
enclosure and tighten the screws. Consult the user's manual for the
external device to configure it for use with the UTX878.
After the UTX878 has been completely installed and wired, reconnect
line power.
•
Check the diagnostics (discussed in Chapter 6, Error Codes
and Diagnostics) to ensure that the UTX878 has been properly
set up.
•
Refer to Chapter 2, Programming Site Data, to program the
meter for taking flow rate measurements.
Installation