Introduction; Entering Global Units - GE UTX878 Ultrasonic User Manual

Introduction

Entering Global Units

Configuring Meter Data
The CONFIG menu in the UTX878 User Program enables you to set
global parameters for the meter that suit your individual preferences.
The available parameters include:
•
Metric or English units
•
4-20 Loop Settings (low and high values)
•
Communication settings
•
Resetting totals
To enter the CONFIG menu from the display screen, press [ESC] (to
enter the User Program) and press the [ ] key once. While following
the programming instructions, refer to Figure A-2 on page A-2 of
Appendix A, Menu Maps.
Note: If the program is locked, follow the directions on page 2-2 to
unlock the user program.
In the Units submenu, you can choose to display all measurements in
either metric or English formats.
Note: You cannot choose to display some measurements in English
formats and others in metric.
To access the Units submenu:
1. Press [ESC]. The UTX878 enters the User Program.
2. Press the [ ] key until CONFIG is bracketed and press [ENT].
3. Press [ENT] to enter the Units submenu.
4. Use the [ ] and [ ] keys to scroll to the desired selection (metric
or English) and press [ENT]. The UTX878 returns to the CONFIG
menu.
IMPORTANT: On any menu, if you scroll to a different option, press
[ENT] twice to select that option (once to enter and
again to confirm the selection).
March 2004
4-1