Input Selection - Barco R9002390 Owner's Manual

Connections
Pin configuration 4 pin connector
3
1
2
4

Input selection

With the RCU or built-in RCU : press digit button 2
Input Priority setting
Depending on the priority setting in the 'Picture Tuning menu', Video or S-Video can be displayed.
If the setting is not correct, handle as follow :
1 Press ADJUST key to start up the adjustment mode. The main menu will be displayed (menu 1).
2 Select 'Service Menus'.
3 Press ENTER to select.
A warning menu, 'risk of incorrect adjustment', will be displayed (menu 2).
4 Press ENTER to continue if you are qualified, or EXIT if not.
When ENTER is pressed, the 'Adjustment main menu' will be displayed (menu 3).
5 Select 'Random Access'.
6 Press ENTER to select.
The 'Choose a setup pattern menu' will be displayed (menu 4).
7 Select 'Selected source'.
8 Press ENTER to display the 'Random Access' menu (menu 5).
9 Select 'Picture Tuning'.
10 Press ENTER to display the picture tuning menu (menu 6).
11 Select 'Port2 : Video'.
12 Press ENTER to toggle between VIDEO or S-VIDEO.
13 Press ADJUST to return to operational mode.
MAIN MENU
Image Control
IRIS Control
Sound Control
Function keys
Service Menus
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
RANDOM ACCESS
ADJUSTMENT MODE
PICTURE TUNING
GEOMETRY
CONVERGENCE
COLOR SELECT
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 5
Note
When using the Port 2 loop-through output, set the Termination switch in the 'OFF' position.
2-4
For S-video:
Pin 1: earth(ground) luminance
Pin 2: earth(ground) chrominance
Pin 3:luminance signal(Y)
1Vpp ±3dB
Pin 4:chrominance signal(C)
300mVpp ±3dB
WARNING
Risk of incorrect
adjustment of the projector
The following
SERVICE menus
are reserved to,
and to be performed only
by qualified personnel !
If qualified, press
<ENTER> to continue, or
if not, <EXIT> to return.
menu 2
PICTURE TUNING
COLOR BALANCE
SYNC : FAST
PORT2 : VIDEO
LINE DOUBLER : ON
Select with é or ê
<ENTER> to accept
<EXIT> to return.
menu 6
For video:
Pin 1:earth(ground) video
Pin 2:not connected
Pin 3:video signal
Pin 4:not connected
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 3
Choose a setup pattern
from below :
SELECTED SOURCE
GENLOCKED PATTERN
INTERNAL # PATTERN
Source 01
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 4
5976064 BARCOCINE 8 25012000