Copy A Block; What Can Be Done; Identification; What Can Be Seen - Barco R9002390 Owner's Manual

Service Mode

Identification

What can be seen ?

The 'Identification' screen gives information concerning :
- Projector address. To change the address of your projector, contact a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be
the same as the baud rate of the connected computer. When there is a difference, contact a qualified service technician to make
the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be displayed and if warnings and failures will be dis-
played.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.

How to start up ?

To select Identification :
1. Push the cursor key é or ê to highlight Identification (menu 1).
2. Press ENTER to select.
The identification screen will be displayed (menu 2).
SERVICE MODE
IDENTIFICATION

COPY A BLOCK

DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
MORE ...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Copy a block

What can be done ?

The copy a block function copies the settings of a selected block into the active block.
8-2
CINE 8
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
menu 2
5976064 BARCOCINE 8 03052000