Table of Contents
Advertisement
Getting Started
Before using the RCU
The RCU is default programmed with address 0 or 1, 'common address'. With that 'common address' programmed into the RCU, every
projector, without exception will listen to the commands given by this RCU. If it is necessary to control a specific projector, than enter
the projector address into the RCU (only when that address is between 0 and 9). The projector with the corresponding address will
listen to that specific RCU.
Display the Projector Address on the Screen.
Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address will be displayed in a 'Text box' (menu 1).
This text box disappears after a few seconds.
To continue using the RCU with that specific address, it is necessary to enter the same address with the digit buttons (address between
0 and 9) within 5 seconds after pushing the address key. For example : if the Address key displays projector address 003, then press
"3" digit button on the RCU to set the RCU's address to match the projector's address. Do not press 003 digits. This will address the
remote control to '0' and control all projectors in the room.
If the address is not entered within 5 seconds, the RCU returns to its default address (zero address) and control all projectors in the
room.
How to program an address into the RCU?
Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address with the digit buttons within 5 seconds after
pushing the address key. That address can be any digit between 0 and 9.
Controlling the Projector
Input selection modes
Source No Projector input
1
Comp. Video
2
S-Video/Comp. Video
3
RGB
4/5
RGB
4/5
Component Video
4/5
RGB with Tri level sync 7
4/5
Component Video with
Tri-level sync
Input Selection via the RCU.
With the digit buttons, it is possible to select one of the above input modes.
3-6
PROJECTOR ADDRESS
001
Press button
1
2
3
4 or 5
6
8
5976064 BARCOCINE 8 25012000
Advertisement
Table of Contents
