Horizontal Size Adjustment; What Can Be Done; Start Up; Hint - Barco R9002390 Owner's Manual

Random Access Adjustment Mode

Start up

To correct the Seagull Correction :
1. Push the cursor key é or ê to highlight SEAGULL CORRECTION (menu 1)
2. Press ENTER to activate.
Eliminate the deformation by pushing the cursor key é or ê until a straight line is obtained (image 1).
TOP-BOTTOM (N-S)
H CENTERLINE BOW
H CENTERLINE SKEW
TOP KEYSTONE
TOP BOW
BOTTOM KEYSTONE
BOTTOM BOW
SEAGULL CORRECTION
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1

Horizontal Size Adjustment

What can be done ?

To adjust (correct) a little bit the horizontal picture size (when the projector is on its correct position) in regard with the installed screen
Start up
1. Push the cursor key é or ê to highlight 'H Size' (menu 1).
2. Press ENTER to activate (menu 2).
3. Push the cursor key ç or è until the exact image width is obtained (horizontal size) (image 1).
Note :
- If the internal # pattern was selected, this pattern remains on the screen.
- If the genlocked pattern was selected, the external source will be displayed.
A bar scale and a numeric indicator help to gauge the size adjustment.

Hint

In order to avoid loss of resolution in the projected image and to ensure maximum CRT longevity, do not use an excessively small
horizontal size setting.
GEOMETRY
H PHASE
RASTER SHIFT
LEFT-RIGHT (E-W)
LEFT SIDE CORRECTIONS
TOP-BOTTOM (N-S)
H SIZE
V LINEARITY
V SIZE
BLANKING
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
H size too
large
H size too
small
image 1
7-20
image 1
menu 2
Ideal image width
H SIZE
70
5976064 BARCOCINE 8 09022000