Memory Banks; Common Address - Barco R9002390 Owner's Manual

Memory banks

What can be done ?
The user has the possibility to create 8 different memory banks (formats) for each source. But, the maximum allowed quantity of
menory banks for all sources together is 32.
The option to create different memory banks for the same source can be switched ON or OFF.
How to select Memory Banks ?
1. Push the cursor key é or ê to highlight 'Memory Banks' (menu 1).
2. Press ENTER to toggle between ON and OFF.
ON : different memory banks available.
OFF : only one memory bank available.
If different memory banks are available for a source and the memory bank option is toggled to OFF, only the first memory bank
will be used to display the source.
How to create a new memory bank ?
1. Select your source. The projector selects the last used memory bank.
2. Press ENTER
3. Push the corresponding digit (between 1 and 8) of a non existing memory bank. (The memory banks can be created in random
order, e.g. first creating bank 5 and later bank 2.)
4. Make the necessary adjustments. When leaving the source, the new created memory bank will be saved for later use.
Example : When source 1, video 15.6 kHz /60Hz is create on bank 4 and the vertical frequency changes to 50Hz, the projector will
create a new block (due to the vertical frequency change) with the same bank number 4.
How to recall a specific memorybank for the actual source ?
When the memory bank option is ON and a source is selected, this source will be displayed with the last used memory bank settings.
An on-screen menu will give a indication of the memory bank nummer used. To switch to another memory bank :
1. Press ENTER to select the next memory bank in increasing order.
or
2. Enter the number of the desired memory bank with the digit keys.
In both cases, the on-screen indication will be update.
SERVICE MODE
DYNAMIC ASTIGMATISM
G2 ADJUSTMENT
GAMMA CORRECTIONS
CRT RUN IN CYCLE
PROJECTOR WARM UP
CRT DRIVE MODE
MEMORY BANKS

COMMON ADDRESS

MORE ...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Common Address
What can be done ?
Every projector listens to a common address. This common address can be set to '0' or '1'. When a RCU is programmed with that
common address, every projector with that same common address will follow up the commands given by that RCU.
Why 2 different common address ?
The reason to have the choice to select between common addresses is, to avoid controlling of other IR controlled units, e.g. a TV
set with standard common address 0.
5976064 BARCOCINE 8 03052000
SOURCE
XX
MEMORY
BANK
4
menu 2
Service Mode
8-11