Contents Infrared Emitter: IRP2 Introduction...1 Description...1 Package Contents ...2 Installation...2 Attach the IRP2 to the IR Sensor Window ...2 IR Mask Installation...3 Attach the IRP2 to Other Locations...3 Connect the IRP2 ...4 Further Inquiries...5 Future Updates ...6 Return and Warranty Policies ...7 Merchandise Returns / Repair Service...7...
Infrared Emitter: IRP2 Introduction The IRP2 is an infrared emitter housed in a plastic shell. The IRP2 shell emits IR control signals sent to it by a Crestron shell can be installed directly on the IR sensor window of the controlled device or at a nearby suitable location.
CAUTION: Test the silicon adhesive on a non-visible area to confirm that it will not damage material or equipment. 3. Affix the IRP2 in the center of the IR sensor window on the front panel of the controlled component. 4. Use a piece of non-damaging tape to hold the IRP2 in position while the silicon adhesive cures.
Crestron IRP2 IR Mask Installation The IR mask (supplied) is designed to fit over the IRP2 shell, as shown in the following illustration, so that the sensor window of the controlled component is completely covered. The IR mask prevents unwanted external IR signals from passing through or leaking past it.
IR sensor window, as shown in the following illustrations, may provide a more pleasing aesthetic appearance. However, be sure to position the IRP2 shell so that the edge of the component does not block the IR signal.
Crestron website (http://www.crestron.com) for a listing of Crestron worldwide offices. You can also log onto the online help section of the Crestron website to ask questions about Crestron products. First-time users will need to establish a user account to fully benefit from all available features.
Infrared Emitter As of the date of manufacture, the IRP2 has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. NOTE: This device complies with part 15 of the FCC rules. Operation is...
CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any application other than that for which it was intended, or if it has been subjected to misuse, accidental damage, modification, or improper installation procedures.
Page 12
Crestron Electronics, Inc. Installation Guide – DOC. 8168A 15 Volvo Drive Rockleigh, NJ 07647 12.04 Tel: 888.CRESTRON Fax: 201.767.7576 Specifications subject to www.crestron.com change without notice.