Background - Barco R9010300 Owner's Manual

10. Signal menu
4. Use ↑ or ↓ to select Output frame rate.
5. Press → to pull down the menu.
6. Use ↑ or ↓ to select the desired frame rate.
The following choices are possible:
- synchronous : the output follows the input frame rate.
- 50 Hz : output is always displayed with a frame rate of 50 Hz
- 60 Hz : output is always displayed with a frame rate of 60 Hz
7. Press ENTER.
Image 10-3

10.4 Background

Purpose
If there is no signal connected to the projector, the background will be a logo, a black or a blue screen depending on the background
settings.
How to change the background ?
1. Press MENU to activate the Tool bar.
2. Press → to select the Signal item. (image 10-4)
3. Press ↓ to pull down the Signal menu.
4. Use ↑ or ↓ to select Background.
5. Press → to pull down the menu.
6. Use ↑ or ↓ to select the desired background.
7. Press ENTER.
Image 10-4
The logo display is only possible in the full screen mode, a logo can thus not be displayed (rescaled) in a
window in the PiP mode.
When there is no signal connected, the projector will also start its standby timer countdown (if enabled) and
shuts down after the predetermined time.
102 R5976817 RLM H5 17/01/2005