Table of Contents
Advertisement
6.5 Lamp power
The projection lamp can be run at different power levels. Higher levels give higher brightness and shorter lamp
life time. Lower levels save energy, extend lifetime and reduce brightness. In the menu system, go to PICTURE >
LAMP POWER and adjust the setting according to need.
6.6 Source selection, source scan
The projector can automatically scan through all the input connectors for a valid signal. If a valid signal is found,
the image will set up automatically. This is called source scan.
Source scan is by default disabled. When source scan is disabled, the projector will only display the selected
source. Use the keypad, remote control or the control interface to change the selected input source. In the menu
system, go to INSTALLATION > SOURCE SCAN.
Direct source selection can be done using the keypad or the wireless remote control.
•
Using the keypad, press the arrow keys to select desired source (when not in menu and not shifting the
lens)
•
Using the wireless remote control, press the desired dedicated source select button
•
Using the RS232 or LAN control interfaces, please see the relevant SIS (Simplified Instruction Set) commands
available to download on www.barco.com
6.7 On screen display (OSD) messages
When detecting sources and using the various features of the projector, OSD messages will appear on the screen.
Which messages will be appearing can be partially controlled by the user. The OSD can run in these modes:
•
On. All messages, warnings and information is displayed.
•
Off. No messages are shown.
•
Only warnings. Only critical warning messages like temperature overheating will be shown.
Go to menu entry INSTALLATION > OSD ENABLE to control the OSD behavior.
6.7.1
Disabling the STATUS indicator
In certain installations it may be necessary to completely disable the STATUS indicator in the keypad. Disable the
indicator in the menu SETTINGS > LED INDICATORS MUTE.
6.7.2
Setting the background color
The background color displayed when the projector is searching for a source can be set to a set of predefined
colors (white/grey/black). Go to menu entry SETTINGS > BACKGROUND to set the desired color.
6.7.3
Setting OSD menu timeout
If the OSD menu is open and not used for a defined period of time, it will automatically be disabled. This timeout
interval can be regulated from 5 seconds to 60 seconds, with the default time set to 30 seconds. The timeout
can also be set to NEVER for the OSD menu to never time out. Go to menu entry SETTINGS > MENU TIMEOUT to
change the time period.
53
•
Hide quick links:
Advertisement
Table of Contents
