Auto Image Setup - Barco R9010300 Owner's Manual

13. Display Setup
6. Quit with BACK.
Image 13-12
Sliderbox position
X position : 619 Y position : 618
Press <ENTER> for fine adjustment
Image 13-13
There is a coarse and a fine adjustment of the position, use ENTER (when sliderbox is displayed) to switch
between the two.

13.8 Auto Image Setup

What can be done ?
Auto image allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the DLP panels.
Auto image can adapt the image based on following data :
• Total pixels per line and total lines
Start pixel and start line
•
• Phase
• Contrast/brightness levels
Auto image works only for data signals.
How to set up Auto Image?
1. Press MENU to activate the menu bar.
2. Press → to select the Display setup item. (image 13-14)
3. Press ↓ to pull down the Display setup menu.
4. Use ↑ or ↓ to select Auto Image setup.
5. Press ENTER to confirm.
A dialog box is displayed. (image 13-15)
6. Check first Enabled.
All other items in the list become available. (image 13-16)
7. Use the arrow keys to select the desired item and press ENTER to enable or disable that item.
124 R5976817 RLM H5 17/01/2005