Switching Off; Temperature Error Dmd; Using The Rcu - Barco R9010300 Owner's Manual

Switching to Standby. When the projector is running and you want to go to standby, press the standby key for
2 seconds until the message 'Saving data, please wait' is displayed. Do not press any longer on the standby
key otherwise the projector will restart.

4.5 Switching off

How to switch off the projector?
1. Press first Standby.
2. Let cool down the projector until the fans stop blowing, at least 15 min.
3. Switch off the projector with the power switch.

4.6 Temperature error DMD

Overview
When the temperature of one of the DMD is too low or too high the projector will be switched automatically to standby. Before
switching to standby, the following message appears for 3 seconds on the screen : 'DMD out of operating temperature range.
Automatic shutdown is activated.'.
Ambient temperature range within the operating temperature range of the DMD is situated : +10°C and +40°C.

4.7 Using the RCU

Pointing to a reflective screen
1. Point the front of the RCU to the reflective screen surface. (image 4-4)
IR Sensor (C)
Remote Control (A)
Image 4-4
Pointing RCU to the screen
A Remote control
B Screen
C IR sensor
When using the remote control, make sure you are within the effective operating distance.
The operating distance may be up to 15 m (50ft).
The remote control unit will not function properly if strong light strikes the sensor window or if there are
obstacles between the remote control and the IR sensor.
R5976817 RLM H5 17/01/2005
Screen (B)
4. Getting Started
39