Table of Contents
Advertisement
What to do if the image is not perfect ?
If the displayed image is not correct after AutoImage or after selecting the best fitting file, go to the Edit menu, select the active file
and change the settings.
12.4 File selection
How to set the filter ?
1. Press MENU to activate the menu bar.
2. Press → to select the Image files item. (image 12-3)
3. Press ↓ to pull down the Image files menu.
4. Use ↑ or ↓ to select File selection.
5. Press → to pull down the selection.
6. Use ↑ or ↓ to select the desired filter.
All
all files that can be loaded will be displayed.
Fit
only the best fitting files will be displayed.
Image 12-3
12.5 Auto Image
What can be done ?
Auto Image creates the best suited image file for the connected source.
It calculates/measures several source parameters :
•
Total pixels per line
•
Start pixel
•
Phase
•
Contrast/Brightness levels
Auto Image works only for data images.
The measure of the total number of pixels per line can be done through 2 methods
•
Limited scan: a windowing is used to allow fast tracking.
The operation takes about 20 seconds (depending on file)
•
Full scan: tracking is done over the full range.
The operation takes about 1.5 minutes (depending on file)
R5976817 RLM H5 17/01/2005
12. Image Files Menu
109
Advertisement
Table of Contents
