Lamp Power; Source Selection, Source Scan; On Screen Display (Osd) Messages; Setting The Background Color - Barco F50 User Manual

6.5 Lamp power

6.6 Source selection, source scan

6.7 On screen display (OSD) messages

6.7.1 Disabling the STATUS indicator

6.7.2 Setting the background color

6.7.3 Setting OSD menu timeout

6.7.4 Selecting the startup logo

51
Downloaded From projector-manual.com Barco Manuals
The projection lamp can be run at different power levels. Higher levels give higher brightness
and shorter lamp life time. Lower levels save energy, extend lifetime and reduce brightness.
In the menu system, go to PICTURE > LAMP POWER and adjust the setting according to
need.
The projector can automatically scan through all the input connectors for a valid signal. If a
valid signal is found, the image will set up automatically. This is called source scan.
Source scan is by default disabled. When source scan is disabled, the projector will only dis-
play the selected source. Use the keypad, remote control or the control interface to change
the selected input source. In the menu system, go to INSTALLATION > SOURCE SCAN.
Direct source selection can be done using the keypad or the wireless remote control.
• Using the keypad, press the arrow keys to select desired source (when not in menu and
not shifting the lens)
• Using the wireless remote control, press the desired dedicated source select button
• Using the RS232 or LAN control interfaces, please see the relevant SIS (Simplified In-
struction Set) commands available to download on www.barco.com
When detecting sources and using the various features of the projector, OSD messages will
appear on the screen. Which messages will be appearing can be partially controlled by the
user. The OSD can run in these modes:
• On. All messages, warnings and information is displayed.
• Off. No messages are shown.
• Only warnings. Only critical warning messages like temperature overheating will be
shown.
Go to menu entry INSTALLATION > OSD ENABLE to control the OSD behaviour.
In certain installations it may required to completely disable the STATUS indicator in the key-
pad. Disable the indicator in the menu SETTINGS > LED INDICATORS MUTE.
The background color displayed when the projector is searching for a source can be set to a
set of predefined colors (white/grey/black). Go to menu entry SETTINGS > BACKGROUND
to set the desired color.
If the OSD menu is open and not used for a defined period of time, it will automatically be
disabled. This timeout interval can be regulated from 5 seconds to 60 seconds, with the
default time set to 30 seconds. The timeout can also be set to NEVER for the OSD menu to
never time out. Go to menu entry SETTINGS > MENU TIMEOUT to change the time period.
When the projector is starting up, a logo is displayed in the entire image. The logo can also
be set to BLACK if it is desirable to disable the manufacturers default logo. Go to menu entry
SETTINGS > SPLASH to change this setting.