Set Port Spantree; Set Port Spantree Cost - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
switchback-interval
none
Example:
P460-1# set port redundancy-intervals 100 20

set port spantree

User level: read-write, admin.
Use the set port spantree command to enable or disable the spanning tree
mode for specific switch ports.
The syntax for this command is:
set port spantree {enable|disable} [module/port]
enable|disable
Module
Port
Example:
P460-1# set port spantree enable 3/1
port 3/1 was enabled on spantree

set port spantree cost

User level: read-write, admin.
Use the set port spantree cost command to set the cost of a port. This value
defines which port will be allowed to forward traffic if two ports with different costs
96
The period the primary port link has to be
"up" before the system switches back (in
milliseconds).
• If switchback interval is zero, the system
never switches back
• If it is one, switchback occurs immediately
after the primary port link returns
The system switches bank only if the
secondary link fails.
Enables or disables the spanning tree mode for the
specified ports.
Module number
Port number
Avaya P460 Reference Guide