Ip Rip Authentication Mode - Avaya P460 Reference Manual

Use the no ip rip authentication key command to clear the password.
The syntax for this command is:
[no] ip rip authentication key <password>
password
Example:
To set the authentication string used on the interface "marketing" to be "hush-
hush".
Router-1(configure-if:marketing) # ip rip authentication
key hush-hush

ip rip authentication mode

User level: read-write, admin.
You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode if
necessary.
Use the ip rip authentication command to specify the type of authentication
used in RIP Version 2 packets.
Use the no ip rip authentication command to restore the default value of
none.
The syntax for this command is: [no] ip rip authentication mode
[simple|none]
simple|none
Example:
To specify simple authentication to be used in RIP Version 2 packets on the interface
"marketing".
Router-1(configure-if:marketing) # ip rip authentication
mode simple
Avaya P460 Reference Guide
The authentication string for the interface. Up to 16 characters are
allowed.
The authentication type used in RIP Version 2 packets:
• simple - clear text authentication.
• none - no authentication.
Chapter 2 Avaya P460 CLI Commands
47